Reznor Udap Series Jun 15, 2016

We purchased 75,000, 120,000, 150,000, and 200,000 BTU units, 28 units in total. The 83% efficient rating helped us offset the cost of the upgrade by being eligible for a rebate from our utility. All heaters were installed and work beautifully. The heaters look great! They are installed in a warehouse with great WIFI access so we controlled all 28 individual heat zones using 28 WIFI thermostats from Honeywell. Couldn't be a happier customer! Now management has control of all 28 heaters with... more

Saved A Lot Of Money Oct 23, 2016

AC unit of 8 years died during heat spell and contractors where quoting very high prices to replace. Having some mechanical ability I decided to purchase and install a new unit myself. eComfort guided me through the whole system and the new unit was shipped to Calif. in just a few days. Had new unit installed in two days and had a licensed AC Tech do my start-up. I saved almost $6000 dollars. New project will be a whole house fan system which they also sell.

Good Purchase Nov 10, 2016

Love the color! Very helpful customer service

Panasonic 300cfm Bathroom Fan The Best Jul 28, 2016

I replaced the 100 cfm fan in the bathroom with the Panasonic 300CFMfan. I no longer have a foggy mirror in the bathroom and sometimes I try to fog it up. No more embarrassing stink gas either. After a minute, all objectionable odors are gone. The only draw back is now that it is Winter the cold air rushing under the door and air getting ducked out of the vent register is cold while doing your business. I plan on installing the 150 cfm in my smaller bathroom.

Great For Bedroom Addition Nov 03, 2016

Our new Mitsubishi makes our bedroom an oasis. This mini-split is ultra quiet and takes the humidity out of the air in short order. My husband (who is a Handy Andy) did all the preliminary installation with no problems, we chose to mount the outside unit on a stand made for mini splits rather than to our cement board siding. A licensed HVAC man came in to do the final vac of the lines to get it fired up, and we could then validate the warranty also. We find setting it at 68 degrees works... more